The APSP-650 swing-arm robot is designed for horizontal injection molding machines ranging from 30T to 150T, efficiently handling product and sprue removal. Featuring a single vertical arm, its movements—including up/down, drawing, and spinning—are powered by air pressure, ensuring high speed and efficiency. This cost-effective automation solution enhances productivity by 10-30%, reduces defect rates, improves operator safety, minimizes labor requirements, and enables precise output control to reduce material waste.
Special Features
| Model | APSP-650 |
|---|---|
| Power Source (KVA) | 0.1 |
| Recommended IMM (Ton) | 30T-150T |
| Crosswise Stroke (mm) | 120 |
| Vertical Stroke (mm) | 650 |
| Max. Loading (Kg) | 2 |
| Dry Take-Out Time (Sec) | 1.6 |
| Dry Cycle Time (Sec) | 5.5 |
| Swing Angle (degree) | 30-90 |
| Air Consumption (Nl/Cycle) | 3 |
| Net Weight (Kg) | 36 |
The cycle times mentioned above are based on our internal test standards. In real-world applications, actual cycle times may vary depending on operating conditions and specific usage scenarios.
| Model | APSP-650 |
|---|---|
| A | 1372 |
| B | 1210 |
| C | 530 |
| D | 316 |
| E | 881 |
| F | / |
| G | 225 |
| H | / |
| I | 50 |
| J | / |
| K | 440 |
Specifications and exterior designs may change without prior notice due to continuous improvements. Thank you for your understanding.
Injection Molding Machine PLC Requirements for Sprue Picker Synchronization
Output Signals:
- Mold Open End
- Safety Door
Input Signals:
- Mold Close Enable
- Ejector Forward Enable
Required Utilities:
- Single-Phase Power Supply
- Compressed Air
Reviews
There are no reviews yet.